Difficulty Rating -

This is a cracking Christmas decoration idea. I just know your going to get eggsited by this one. Okay, Less of the foul yokes! But seriously eggs make wonderful Christmas tree baubles.

I don't think that there is anything more festive than making your own Christmas baubles to hang on the Christmas tree whilst listening to Christmas carols, it really makes you feel the spirit of Christmas. Why not make Christmas tree baubles from eggshells? Everyone thinks of eggs at Easter time, but they symbolise new beginnings, like the birth of Jesus Christ.

All you need is...
Some eggs, gift-wrap, ribbon, paint, some wire, glitter and other odds and ends for decoration.

First take your egg in one hand and a darning needle in the other. Hold the egg firmly in your hand and push the needle into the centre of the wide bit, at the bottom of the egg. Once the needle is through, wiggle the needle about a bit to make the whole a bit bigger. Now turn the egg around and make another hole in the top of the egg, again wiggle the needle.

Then with a dish underneath to catch the insides of the egg, blow very hard into one end of the egg, and blow the egg out. DO NOT SUCK! This is very bad.

There are concerns that you can contract salmonella from raw eggs. If you are worried about this you could use a medicine syringe to force air through the eggshell.

Remember not to let the egg go to waste. Make scrabbled egg for your dog or use them to bake some cakes.

Once the eggshell is empty give it a good wash out with disinfectant and leave it to dry overnight. Stand it in an eggcup so any excess water can run out freely.

Give your eggshell a coat of paint. Metallic is nice and festive. Leave the paint to dry.

You need to make an egg threader with a piece of wire, which is about twice the length of the egg. Turn the end over and down to form an 'eye' like you would find on a needle. Wrap some selotape around the turn down bit of wire and the main stem of wire.

Get a length of gift-wrap ribbon, which is roughly 4 or 5 times as long as the egg. Fold it in half and tie a knot in the ribbon about 2cm down, forming the loop for hanging the egg on the Christmas tree.

Insert the threader tool into the tool at the top of the egg and out through the bottom of the egg leaving the eye resting on the top of the egg. Tread the two ends of the ribbon through the eye of the egg threader tool. Gently pull the threader tool and the ribbon through the egg, so that the loop knot you made rests on the top of the egg, and the gift-wrap ribbon dangles out from the bottom of the egg. Tie a knot in these ribbons so that the knot sits at the base of the egg. Tie another length of ribbon to these ribbons at the knot. Pull all the ribbons over a pencil to make the ribbons curl.

Stick a small image from a Christmas card or gift wrapping paper on the side of the egg or create a motif with sequins or other bits and bobs.

Finally, using PVA glue, stick some glitter on to the egg to make it sparkle.

Treat the egg bauble like a glass bauble, pack it away carefully and use it every year. If you don't want to use eggs, try Ping-Pong balls instead.